User guide

Running the QuickSetup Wizard
User Guide 35
Using TCP/IP
Refer to Firebox Rear Panel image on the previous page.
• Use the red (crossover) cable to connect the Firebox Trusted interface
to the Management Station Ethernet port.
• Plug the power cord into the Firebox power input and into a power
source.
Running the QuickSetup Wizard
After you finish setting up the Management Station and cabling the
Firebox, use the QuickSetup Wizard to create a basic configuration file.
The Firebox loads this primary configuration file when it boots. This
enables the Firebox to function as a simple but immediately effective
firewall.
The QuickSetup Wizard also writes a basic configuration file called
wizard.cfg to the hard disk of the Management Station. If you later
want to expand or change the basic Firebox configuration using Policy