User guide

Method 4: Serial Dongle (Firebox II only)
User Guide 233
3 Take out one end of the serial cable from the Firebox to break the loop
effect.
4 On the Management Station, open a DOS prompt. Ping the Firebox
with a 192.168.253.1.
You should get a reply.
5 In Policy Manager, select File => Open => Configuration File. Select
the configuration file you want to load onto the Firebox and load it
into Policy Manager.
6 In Policy Manager, select File => Save => To Firebox. When you are
prompted for an IP address, use 192.168.253.1 with
wg as the
passphrase.
7 When the Firebox Flash Disk dialog box appears, select the button
marked Save Configuration File and New Flash Image.
8 After the file has been restored on the Firebox, you will have to
reassign the IP address of your Management Station such that it is on
the same network as the Trusted Interface from the configuration file
that you just used. This will enable you to reconnect to the Firebox
with the Trusted IP address that is listed in the configuration file and
your status passphrase.