User guide

Method 3: Using the Reset Button - Firebox Models 500, 700, 1000, 2500, 4500
User Guide 231
configuration passphrase. Use the address you used as the temporary
IP address during the flash disk management process and
wg as the
passphrase.
12 When the Firebox Flash Disk dialog box appears, select the button
marked Save Configuration File and New Flash Image.
After the configuration has been uploaded and the Firebox has been
rebooted, the Firebox light sequence should now look like this:
Armed light: Steady
Sys A light: Steady
You should be able to ping the Firebox again with the same IP address
you used earlier. At this point, you should be able to connect back to the
Firebox through Control Center and reinstall the Firebox into the
network.
Method 3: Using the Reset Button - Firebox Models 500,
700, 1000, 2500, 4500
You can use the Reset button method only on the Firebox models 500, 700,
1000, 2500, and 4500. Before you start, assign the IP address of your
Management Station to be on the 192.168.253.0 network. Do not use the
192.168.253.1 address, which is being held by the Firebox as a default. The
subnet is 255.255.255.0.
It is recommended that you give your computer’s default gateway an IP
address of 192.168.253.1.
1 Disconnect the Firebox from the network.
2 Start with the Firebox turned off. Hold down the Reset button on the
back of the Firebox and turn on the Firebox power switch. Do not let
go of the Reset button until you see this light sequence on the front of
the Firebox:
External light on Triangle: Blinks
Trusted => Optional Traffic (Activity): Flashing lights
Sys B: Flickering
Armed: Steady
3 Connect a crossover cable to the Management Station and into the
Firebox Trusted Interface.