User guide

Method 2: The Flash Disk Management Utility
User Guide 229
10 When the Firebox Flash Disk dialog box appears, as shown in the
following figure, select the button marked Save Configuration File
and New Flash Image. Make sure the checkbox marked Make
Backup of current flash image before saving is not selected.
After the configuration has been uploaded and the Firebox has been
rebooted, the Firebox light sequence should look like this:
Armed light: Steady
Sys A light: Steady
You should be able to ping the Firebox again with the same IP address
you used earlier. At this point, you should be able to connect back to the
Firebox through Control Center and reinstall the Firebox back into the
network.
Method 2: The Flash Disk Management Utility
Like the first procedure, this method requires that you disconnect your
Management Station and Firebox from the network.
1 Make sure the Management Station has a static IP address. If it
doesn’t, change the TCP/IP settings to a static IP address. The
computer designated as the Management Station should be on the