User guide

Chapter 8: Configuring Filtered Services
104 WatchGuard Firebox System
Adding service properties
The method used to add incoming and outgoing service properties is
identical. Select the tab, click the Add button for either the From or the To
member list, and then define the members for the category. The direction
of traffic determines how you select members of the From and To lists.
Adding addresses or users to service properties
Both the Incoming and Outgoing properties include From and To address
lists. Use the Add Address dialog box to add a network, IP address, or
specific user to a given service.
1 In the Properties dialog box, use the Incoming service Connections
Are drop list to select Enabled and Allowed.
2 Click either the Incoming tab or Outgoing tab. Click the Add button
underneath the From or the To list.
The Add Address dialog box appears.
3 Click Add Other.
The Add Member dialog box appears.
4 From the Choose Type drop list, click the type of address, range, host
name, or user you want to add.
5 In the Value text box, type the actual address, range, or name. Click
OK.
The member or address appears in the Selected Members and Addresses list.
6 Click OK.
The new selection appears in either the Incoming or Outgoing tab under the
appropriate From or To box.
Tab Member
List
Defines
Incoming From External users or hosts that the service will allow in
Incoming To Destinations within the trusted network that can
receive packets through the service
Outgoing From Users and hosts on the trusted network that can send
packets out through the service
Outgoing To Destinations on the external network to which traffic
for this service can be found