User guide

Adding and Configuring Services
User Guide 101
Ignore
Source port can be any number (0—65565). (If you are not sure
which port setting to use, choose this option.)
Secure
Source port can range from 0—1024.
Port
Source port must be identical to the destination port, as listed in
the Port number field of the destination service’s Properties
dialog box, Properties tab (shown below).
Client
Source port can range from 1025—65565.
8 In the Port field, enter the port number. If you are entering a range,
enter the lowest number of the range.
9 In the To field, enter the highest number of the range. (If you are not
entering a range, leave this field blank.)
10 Click OK.
Policy Manager adds the port configuration to the New Service dialog box. An
example of how this dialog box might look appears in the following figure. Verify
that the name, description, and configuration of this service are correct. If
necessary, click Add to configure an additional port for this service. Repeat the
process until all ports for the service are configured.