User guide

Chapter 12: Support Resources
170 WatchGuard Firebox SOHO 6
SOHO 6 configuration file. These steps apply to using a command
prompt with Windows 2000 or XP.
1 Configure the firewall settings of the SOHO 6 to allow an
incoming FTP service to the trusted IP address of the
appliance.
For information on configuring an incoming service, see Chapter 6
“Configure the Firewall Settings” on page 61.
2 Select Start => Programs => Accessories => Command Prompt.
A command prompt window appears.
3 At the prompt, type ftp and then the IP address of the trusted
network.
The default IP address is: 192.168.111.1
4 Press Enter.
5 You are then prompted for the username and password. Type
the system administrator name and passphrase configured on
the system security page. For information on configuring the
system security page, see “System security” on page 50.
The default values are “user” and “pass”.
6 Respond to the ftp prompt as follows:
ftp>
bin
ftp> get wg.cfg
The wg.cfg file is downloaded to the directory of the original command
prompt.
ftp> bye
The original command prompt reappears.
7Type exit at the prompt and then press Enter.
The command prompt window closes.
VPN Management
See “What You Need” on page 91.