Design for Manufacturing and Environment Document EDGE Wireless De-manufacturing Instructions \ Document Number: 480-2521-001 WatchGuard Technologies. Doc #480-2521-001 Rev.
Design for Manufacturing and Environment Document 1.0 Purpose This instruction defines the de-manufacturing process for the recovery of this product family as it pertains to recycling of the major product components. 2.0 Scope This instruction applies to the following product family and family part numbers. Product Family Name Family part #’s (not necessarily inclusive) Firebox X Edge Wireless • Firebox X5W; all revisions • Firebox X15W; all revisions • Firebox X50W; all revisions WatchGuard Technologies.
Design for Manufacturing and Environment Document 3.0 Instruction 3.1 -Remove wireless antenna and antenna hardware Material removed (P/N & material type) Instruction visual Antenna 1305-002 - TPE, PC, reverse SMA connector, RG178 coaxial cable; 2.4Ghz; 2 ea. Remove antenna by unscrewing from chassis post, 2 sides Post cover 1366-001- Rubber Santoprene 10155A Washer No p/n - Gold plated brass Nut No p/n - Gold plated brass Remove post cover and hardware; 2 sides 3.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Labels Cert.
Design for Manufacturing and Environment Document 3.3 – Remove serial connector standoffs Material removed (P/N & material type) Instruction visual Stand-offs No p/n – Hex-head; stainless steel Remove stand-offs 3.4 – Remove bezel from unit top - depress tabs to disengage; remove light pipe from bezel Material removed (P/N & material type) Instruction visual Painted metal enclosure 1768-001 - 22Ga.
Design for Manufacturing and Environment Document 3.5 –Remove battery; remove screws and separate main PCBA from chassis bottom Material removed (P/N & material type) Instruction visual Battery –coin cell 0301-001– Manganese oxide / Lithium CR2032 Remove battery from clip Remove screws 0863-002 - Phillips head, stainless steel, 4 ea. Remove PCBA screws -4 ea. Separate PCBA from chassis bottom 3.6 –Remove insulator shields from bottom chassis WatchGuard Technologies. Doc #480-2521-001 Rev.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Instruction visual Painted metal enclosure; chassis bottom 1769-001 - 22Ga. EG w/powder coat (Interpon 700 -epoxy/polyester) Insulator shields 1780-001 - Insulator, 31.3mm round, Mylar, 2 ea. 1767-001 - Insulator, 42x221mm, Mylar, 1 ea. Remove EMI shields 3.
Design for Manufacturing and Environment Document Material removed (P/N & material type) Instruction visual RF PCBA 1771-001 - RF PCBA RF Cable 1772-001 - Coaxial cable assembly. 6cm Remove RF Cables from RF PCBA RF Cable 1772-002 - Coaxial cable assembly. 19.5cm 4.0 Applicable Documents 5.0 Revision History REV. NO. A REV. DATE 10/10/2005 REVISED SECTION n/a REASON Initial Release ECO# 0712 WatchGuard Technologies. Doc #480-2521-001 Rev.
