Hardware Guide

WatchGuard Firebox T40/T40-W Hardware Guide
AC Power Adapter
The AC power adapter supplies power for the Firebox. Before you connect the adapter, verify that the color
band on the cord matches the color ring around the power plug on the Firebox.
To safely disconnect the power supply:
Slide the black plastic external housing away from the Firebox to expose the internal silver metal
connector. With the internal silver connector exposed, continue to pull to disconnect the cord.
A Firebox shipped outside the United States includes four power cables to connect to the AC power
adapter. Use the correct power cable for the power source used in your country.
Wall Mounting Plate
The wall mounting plate (available separately) enables you to mount the Firebox on a wall in a good location
to increase the wireless range.
You need four screws 1/8" (3 mm) wide and at least 3/4" (18 mm) long to install the mounting plate.
To install the wall mounting plate:
1. Place the wall mounting plate horizontally against the wall where you want to install the Firebox.
2. Securely screw the wall mounting plate to the wall with the four screws.
3. Align the two holes on the bottom of the Firebox with the two connection points on the mounting plate.
4. Push the Firebox toward the mounting plate, until the two connection points on the mounting plate are
inside the holes on the bottom of the Firebox. Then press firmly down to seat the device on the plate.
To remove the Firebox from the mounting plate, push the Firebox up slightly, and then pull out, to separate
the connection points on the mounting plate from the holes on the bottom of the Firebox.
WatchGuard Technologies, Inc. ix