User Manual
Table Of Contents
- 1 Features
- 2 Safety Symbols used in this Manual
- 3 Safety Guidelines
- 4 Responsibility for Operation or Damage
- 5 Application
- 6 Before Starting
- 7 Installation/ Start-up
- 8 Operation
- 9 Troubleshooting
- 10 Care and Maintenance
- 11 Technical Data
- 12 Disposing of the Unit
- 13 EU Declaration of Conformity
9 Troubleshooting
Fault Cause Solution
Spindles do not stay in
place
Spindles too loose Use light hammer taps to fix spindles in
place
Spindles cannot be
undone
Spindles located
too firmly on
tapers
Contact our service department
Little to no suction Filter bag full Replace filter bag
Bearing noise Faulty bearing Contact our service department
Light does not work LEDs defective ATTENTION: The LEDs right and left are in
series. That means both LEDs do not work
although perhaps only one of them is faulty.
Please check this in advance and replace
only the faulty LEDs.
No function Fuse is demaged Check the fuse.
Disconnect the power plug before starting
any maintenance work.
Change the fuse if necessary:
REF 582031 FUSE 12.5 A T
If the above recommendations do not solve the problem, contact your dental depot
or our service department.
11