User Manual

7 Installation/ Start-up
Before starting the unit:
7.1 Installing and Removing the Brush Spindles
Use compressed air to blow away dust and dirt from the brush spindle.
Remove the disassembly nut by turning it clockwise (left hand thread). Remove grease
from the shaft extension and re-mount the disassembly nut by turning it counter-clockwise.
When doing so make sure the disassembly nut is fully tightened.
Installing the brush spindle:
Install the brush spindle according to its labelling, R=right.
Use a hammer and a piece of plastic to tap the spindle lightly and carefully onto the end of
the taper.
There is a risk of damage to the ball bearing caused by external forces. This
terminates the warranty.
Finally, insert the power plug into the socket, making sure that the mains and the unit
operate on the same voltage.
When the motor is operating, the spindle must to turn centrically. If this is not the case,
please repeat the process.
8 Operation
8.1 General Operating Instructions
All instructions for using the unit, whether in verbal or written form, are based on our own
experience and experimentation and can only be regarded as guidelines.