User Manual
Table Of Contents
- 1 Features
- 2 Safety Symbols used in this Manual
- 3 Safety Guidelines
- 4 Responsibility for Operation or Damage
- 5 Application
- 6 Before Starting
- 7 Installation/ Start-up
- 8 Operation
- 9 Troubleshooting
- 10 Care and Maintenance
- 11 Technical Data
- 12 Disposing of the Unit
- 13 EU Declaration of Conformity
10.2.2 Changing the Integrated LEDs
Disconnect the power plug before starting any maintenance work.
• To open the service covers [A] on the right and left side of the unit unscrew the four
screws [B] by using an Allen wrench.
• Then loose the four knurled screws [C] of the cover [D] inside the unit .
• The cover has not to be removed completely. It can be carefully hinged down and
placed on the engine.
• Resolve the plug connection of the LED power cable.
• Dissolve now the two knurled screws [E] and remove the defective LED strip from
the white retaining plate.
• Then insert the plug of the new LED bar in the plug connector and tighten the new
LED strip with the knurled screws [E].
• Now fold up the cover [D] and tighten the four knurled screws [C] inside the unit
hand-screwed.
• Insert service covers [A] right and left and fix each with the two screws [B].
A
A
B
B
C
C
D
C
C
E