User`s manual

15
4.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings (with the exception of
ribbon sensitivity) to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Press and hold the Feed button while turning the power back on.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during
the 5 blinks).
 The LED color will be changed as following:
Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5
blinks)  red/amber (5 blinks)  solid green
Printer configuration will be restored to defaults as outlined below after initialization.
Parameter Default setting
Speed WPL205, 127 mm/sec (5 ips)
Density 7
Label Width 4.25” (108.0 mm)
Label Height 2.5” (63.4 mm)
Media Sensor Type Gap sensor
Gap Setting 0.12” (3.0 mm)
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Cutter Mode Off
Serial Port Settings
9600 bps, none parity,
8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
Note：
Always do gap/black mark sensor calibration after printer initialization.