User manual

28
WPL 406 User Manual
Speed
6
Density
8
Direction
0
3.1.1-1.1 Speed:
Print Setup 1/12
>
Speed
Density
Direction
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer default
density is 5 ips (203 dpi) or 3 ips(300 dpi).
Press
key to raise the print speed, and press key to decrease print
speed. Press
key to set it into printer. Press key to cancel the
setting and return to the previous menu.
Note: If printing from enclosed software/driver, “Use current printer settings” option
is not selected, the software/driver will send out the SPEED command, which
will overwrite the setting set from the front panel.
3.1.1-1.2 Density:
Print Setup 2/12
Speed
>
Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15 levels, and
the increment is 1 level. Printer default density is 8.You may need to adjust your density
based on selected media/ribbon.
Press
and to increase/decrease the printing darkness. Press
key to enable the setting. Press
key to cancel the setting and return to the
previous menu.
Note: If printing from enclosed software/driver, the “Use current printer settings”
option is not been used, software/driver will send out the DENSITY command,
which will overwrite the setting set from the front panel.
3.1.1-1.3 Direction:
Print Setup 3/12
Speed
Density
>
Direction
The direction setting value is either 1 or 0. Use this option to setup the printout direction.
Printer default printout direction is DIRECTION 0.