User manual

19
WPL 406 User Manual
6. Adjust the label guide to fit the width of the
label. Make sure the media sensor triangle
indicator is on the paper feed path that can
sense the gap or black notch for label sensing.
7. Close the print head mechanism. Make sure the
latches are engaged securely.
8. Use the DiagTool to set the media sensor type and calibrate the selected sensor. (Please refer to
section 4.)
Note:
• Please calibrate the gap/black mark sensor when changing media.
• The sensor location is marked by a triangle mark at the sensor housing.
• The media sensor position is moveable. Please make sure the gap or black mark is at the location
where media gap/black mark will pass through for sensing.
Loading path for roll labels:
Label Guide
Media sensor
indicator
Rear Media Loading
Slot
Media Supply
Spindle
Media Guide Bar
Media Sensor
Platen Roller