User manual

18
WPL 406 User Manual
3. Move the label roll guard horizontally to the
end of the label spindle, then flip down
the label roll guard.
Note: The yellow 3” core adjustors are not on
the label spindle when first opened. You
must slide these onto the spindle.
4. Place the roll of media on the label supply
spindle. Flip up the label roll guard.
Note: When inserting the 3” core adaptor to
the spindle, please make sure the arror
direction is as shown in the figure below.
When using the 1” core media, remove
the 3” core adaptors from the label supply
spindle.
5. Pull the label roll leading edge forward through the media guide bar, media sensor and place
the label leading edge onto the platen roller.
Media Guide
Bar
Media Supply
Spindle
Media Sensor