User Manual

5
In order to configure Wasp CCD LR, you must familiarize yourself with the setup
procedures on the following pages. The default settings of the Wasp CCD LR
are identified on each page and clearly marked using an asterisk (*). The
default settings have been preprogrammed for the most common bar code
configurations. Use the CCD LR Setup & Configuration only to customize
the Wasp CCD LR settings. If you need to configure Wasp CCD LR, the
default settings will be overwritten. All the programmed settings are stored
permanently in non-volatile memory; therefore, your configuration will be
maintained even if the keyboard power to Wasp CCD LR is removed by turning
off your PC.
In order to configure Wasp CCD LR, two basic steps need to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the bar code representing the option to be changed.The scanner will
sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length bar code.
(2) Scan a 2 digit value from the ASCII table on pages 31-34
(3) Scan the Minimum or Maximum Length bar code again.
Chapter 5
CCD LR Setup & Configuration