Operating instructions

SoftCare Evo - Type SE10 7-8
Acid cleaning
Alkaline cleaning
Final work
Chapter 7 - Maintenance and care
Clean the brushes first with an acid cleaner (cleaner
with a pH value < 7) if the water hardness is higher
then 10 ° dH,. If the water hardness is lower you can
start immediately with the alkaline cleaning
(pH-value > 7).
)
Spray the brushes with acid cleaner.
)
Let the cleaner act on the brushes for approx.
10-15 min.
)
Flush the cleaner out of the brushes with a
strong jet and plenty of water.
)
Spray the brushes with alkaline cleaner.
)
Let the cleaner act on the brushes for approx.
10-15 min.
)
Flush the cleaner out of the brushes with a
strong jet and plenty of water.
)
Check the pH-value in the tank system after
cleaning the brushes when the system is
equipped with a water recycling system. The
pH-value must be between 7,0 and 8,0.
)
Wash at least 30 vehicles with fresh water if
the pH-value is below 7.