Operating instructions

SoftCare Evo - Type SE10 3-4
Side brushes
Chapter 3 - Structure and function
The side brushes are connected directly to the rotary
drive by rollers. The side brushes are mounted on a
moving bearing for precise adaptation to the vehicle
contours.
Fig. 3-4: Side brushes on movable bearings
During the wash stage, the vehicle contour is memo-
rised. The microprocessor control system regulates
the position and consequently the application pres-
sure of the side brushes on the basis of these meas-
ured data.
The roll-over car wash system is pre-set in the
factory with the optimum settings for the type of
brushes installed on commissioning. If other
brush materials are subsequently used, adjust-
ments must be made by WashTec Service.
Only original WashTec brushes and coverings
may be used. If other brushes are used, no guar-
antee whatsoever can be provided for the func-
tion of the system.
NOTICE