Operating instructions

SoftCare Evo - Type SE10 9-7
Symbols for manual
operation
Symbols for special
functions
Symbol for starting
the service program
Fig. 9-5: Symbols
Chapter 9 - Operating units
Numeric keys
Numeric keys are used to select programs and to
enter data in the service programs.
Selection buttons
The lowest line of the display shows up to four
symbols:
Fig. 9-4: Display of symbols
Use the buttons <<§>> and <<¨>> to display fur-
ther symbols. All available symbols are shown on the
left side.
The symbols for manual operation (control buttons)
are used for manual operation of individual machine
elements such as roof brush, side brushes or the
whole gantry (more information in chapter 9.5).
The symbols F1 – F3 are used to start special func-
tions which have been previously assigned by
WashTec Service.
The symbol P is used to start the service program.