Operating instructions

ManualsBrandsWascomat ManualsHousehold AppliancesEXSM 350 HI-TEK

Main wash

The main wash lasts for approximately 8 minutes

and begins by filling with hot water and dispensing

detergent from compartment 2 (peg no. 8 in rib C

cut away).

The programmer stops the card at peg no. 8 until

the water level is reached.

Rib Q is cut away for the entire main wash to

ensure that the water level is maintained during

the entire wash procedure. The running time once

the required level has been reached is 6 minutes

(peg nos. 8-23 removed from rib Q).

The main wash is concluded with Drain for one

minute (peg nos. 24 and 25 in rib D removed).

Rinse cycles 1-3

Rinse cycles 1-3 each last for approximately 2

minutes and are identical. The following descibes

rinse cycle 1. The rinse cycle begins with Filling

with cold water to high level (peg nos. 26-29 in ribs

N and Q are cut away).

The programmer stops the card at peg 26 until the

water level is reached. The running time once the

water level is reached is 2 minutes.

The rinse cycle is concluded with Drain for 1.5

minutes and with extraction for the last 30 seconds

(peg nos. 30-32 in rib K and peg no. 32 in rib H

removed).

Rib K must always be programmed parallel with rib

H to achieve the extraction cycle. SInce extraction

must not be operated with the drum filled with

water, rib K (Drain) is programmed 2 pegs earlier

that the extraction cycle to drain the water before

the extraction cycle starts. The machine also has a

level guard to ensure that the extraction cycle

cannot start while there is water in the drum.

Card programming

1746

1745

A. Detergent, (1)

B. Not used (heating)

C. Detergent, (2)

D. Not used (heating)

E. Extern supply

F. Extern supply

G. Extern supply

H. Extraction

I. Fabric softener, (3)

K. Drain

L. High speed extr.

M. Stop with buzzer

N. High level

O. Cold water

P. Cool down

Q. Hot water

Rinse 1

Extraction

Draining

Filling with water

and fabric

conditioner

Rinse 2

Rinse 3