Operating instructions

23
When Cool down is programmed (rib P) the
machine is filled with cold water. Th amount of
time chosen depends on the temperature desired.
The cooling rate is approximately 3-4°C/min.
Programming Extraction (rib marked H) shall
always be preceded by Drain (rib marked K). This
shall also be programmed during the entire extract
cycle.
Programming Stop with signal (rib marked M) can
be carried out several times during the same wash
program. When the program comes to Stop, a
buzzer sounds and the machine stops. Press
RESTART to restart the machine.
RESTART may not be used without having a
program card inserted in the machine.
Use ribs C, I, A, E and G for signals when
connecting external supply dispensing equipment.
Programming example
A card which is programmed for normal soiled was
as follows:
Pre-wash
The pre-wash lasts for approximately 3 minutes
(peg nos. 0 to 6) and begins with Filling with cold
water and hot water to a high water level and
dispensing of detergent from compartment 1 (peg
no. 0 in ribs N, A, O and Q cut away).
Ribs N, A, O and Q are cut at peg no. 1 as a
safety measure to ensure that the wash cycle is
correct even though the program card may be
pushed too far into the program controls.
The programmer stops the card at peg no. 0 until
the water level is reached. The running time once
the water level and required temperature are
reached is 2 minutes (peg nos. 1-5 cut away in
ribs N, O and Q).
Ribs B, I and Q are cut away for the entire
prewash to ensure that the temperature and water
level are maintained during the entire wash
sequence. It is usually necessary to top up with
water since the dry wash goods soak up a certain
amount.
The pre-wash is concluded with Drain for one
minute (peg nos. 5 and 6 in rib K cut away).
Card programming
40
A. Detergent, (1)
B. Not used (heating)
C. Detergent, (2)
D. Not used (heating)
E. Extern supply
F. Extern supply
G. Extern supply
H. Extraction
I. Fabric softener, (3)
K. Drain
L. High speed extr.
M. Stop with buzzer
N. High level
O. Cold water
P. Cool down
Q. Hot water
1744
41
1743
A. Detergent, (1)
B. Not used (heating)
C. Detergent, (2)
D. Not used (heating)
E. Extern supply
F. Extern supply
G. Extern supply
H. Extraction
I. Fabric softener, (3)
K. Drain
L. High speed extr.
M. Stop with buzzer
N. High level
O. Cold water
P. Cool down
Q. Hot water
Filling with water
and detergent
Washing
Rest position
(programmed as row 0)
Draining
Extraction
Drain before and
during extraction
Fig.
40
Fig.
41