Operating instructions

21
Card programmer
Gentle action. This feature is standard on all FL’s.
You select this feature by pressing the manually
operated switch on the front of the control panel. It
is ideal for blankets, draperies, slipcovers, and all
fragile materials where reduced mechanical action
is desirable. The washer will function as follows:
A During washing and rinsing, the tumbling
action of the basket will be 3 seconds
clockwise and stop for 12 seconds. Direction
will reverse and run 3 seconds counter-
clockwise and stop for 12 seconds. This
procedure will continue, resulting in a
reduction in mechanical action.
Programming, when using powder supplies
Rib function description:
A- Flushing detergent from compartment 1.
Programmed for 30 seconds together with
water filling. If the water pressure is low,
detergent supply should occur after water
filling. Detergent supply can not be
programmed before water filling. If external
liquid supply is used, signal is given to
terminal 1 at the rear connection block.
B- If heated, thermostat 1.
C- Flushing detergent from compartment 2.
Programmed for 30 seconds together with
water filling. If the water pressure is low,
detergent supply should occur after water
filling. Detergent supply can not be
programmed before water filling. (*If
external liquid supply is used, signal is
given to terminal 2 at the rear connection
block).
D- If heated, thermostat 2.
E- If external liquid supply us used, signal is
given to terminal 3 at the rear connection
block.
**F-If external liquid supply is used, signal is
given to terminal 2 at the rear connection
block.
G- If external liquid supply us used, signal is
given to terminal 4 at the rear connection
block.
H- Extraction. Important: Drain must be cut
for 60 seconds before extraction and during
entire extract cycle.
* Up to machine No. 96/196.
** From machine No. 96/197.
37
0427
Fig.
37