Operating instructions

Mechanical and electrical design

Control unit

All major components for operating the machine, such as card programmer (3) the

thermometer (4) and push-buttons (5) are mounted on the control panel (1) at the front

of the machine.

Components such as relays and reversing timer are mounted in the control unit (2)

located at the top of the machine, easily accessible for service after removing the top

panel.

The control unit is mounted in the machine with 4 screws. Connections to the machine

are made by quick-disconnect plugs. Two thermostats (14) are supplied for heated

machines.

Manual operating switches

Switches with following functions are mounted on the control panel:

Programmer switch

The black knob (6) on the card programmer acts as a main switch for starting and

stopping the machine when washing with a pre-cut formula card. See chapter

’’Operating instructions’’.

ON-OFF switch with signal light (7)

This switch must be in ’’On’’ position with the built-in signal light indicating that there is

power to the machine before the machine can be operated including normal door

opening.

Re-start switch with signal light (8)

is used to re-start the programmer after the buzzer has sounded and the programmer

stopped.

Gentle action switch (9)

is used to obtain a gentle wash action when washing delicate garments. The drum

rotates 3 seconds in one direction, stops for 12 seconds and then operates again for 3

seconds in the opposite direction.

1767

Fig.