Operating instructions

0416

1760

Function control check-out list

In the machine cylinder, you will find the warranty

registration card, a copy of the warranty policy, the

bolt hole template and other pertinent material.

The warranty card should be completed and sent

to Wascomat. All other items should be placed in a

safe place for future reference.

The machine should be cleaned when the

installation is completed, and checked out as

detailed below without loading the machine with

fabrics:

1. Check the incoming power for proper voltage,

phase and cycles.

2. Open manual shut-off valves to the machine.

3. Turn on electric power.

4. Check the door safety interlock as detailed on

page 11 of this manual.

5. Push the ON-OFF switch to the ''ON'' position.

Turn the programmer knob clockwise and insert

the formula card. Start the machine by now

turning the programmer knob counter

clockwise.

6. Run through a complete cycle, checking for

water temperature and drain operation as cut

on the card.

7. Machine must spin in a counter-clockwise

direction, as seen from the front, during

extraction. If it does not, reverse lines L1 and

L3.

NOTE

All machines are factory tested prior to

shipment. Occasionally, some residual water

may be found when the machine is installed.

Installation

Fig.