Operating instructions

8
Installation
14
15
2367
2368
Water connection
NOTE
All plumbing must conform to national and
local plumbing codes.
Incoming water lines do not require non-return or
back-suction valves, as the machine is already
fitted with a siphon breaker. However, all incoming
lines must be fitted with shut-off valves.
• Water inlets are labelled for connection of hot
and cold water hoses.
• Flush the water system thoroughly and check
that the filter at the machine inlet is fitted
correctly.
• Connect the machine to the water mains with
1'' reinforced rubber hosing not to exceed 6 ft in
length. Hang the hosing in a large loop. Do not
use rigid piping.
Drain connection
Connect a 3'' (75 mm) flexible hose to the drain
outlet of the machine.
The drain hose must not have any sharp bends
and must slope from the machine to assure proper
drainage. The outlet must open freely to the main
drains or a 6-inch minimum PVC drain line.
Do not reduce the size of the drain connection
from the machine to the waste line.
Fig.
16
Fig.
14
Fig.
15
Fig.
17
17
1761
16
0283