Operating instructions

2400

Mechanical installation

• Place wide steel shims on the concrete

foundation over the bolts.

• Lift the machine and lower it in position. Never

use the door or the door handle to lift or lower

the machine.

• Check that the machine is level front-to-rear

and side-to-side and standing firmly on the ten

supporting points. Spacing washers must be

mounted if one or more of these points is not

resting against the floor/foundation.

• Place flat washers over the foundation bolts

and secure the machine in position by

tightening the self-locking nuts, with a torque of

20 kpm.

Torque for the nuts (M16) should be 145 ft lbs.

• Tighten the nuts in sequence as shown.

• Check and tighten the nuts every week for the

first month.

Installation

Fig.

2402

2399

2401