Operating instructions

40
Water level controls
One pressure switch (1) is used to control the
correct water levels during various cycles of the
washing program.
Adjustment
All pressure switches are factory-calibrated to
meet specific requirements. The trip level for
any one pressure switch can be changed only
within narrow limits because each trip range
requires a different set of springs.
Water level
As a guide for checking the level control for
proper functioning, the low level should be
when the water just reach to the top of the
paddle (1), and the high level when the water
just reach the outer edge of the tapered section
in the rear of the of the drum (2).
Mechanical and electrical design
58
59
0904
1
Fig.
58
Fig.
59
0907