Operating instructions

46
If motor does not operate at wash speed
A Check wash relay.
B Check motor and V-belt.
C Check reversing mechanism.
D Review procedures outlined under Section 1 above.
If machine runs slowly on wash speed or there is a slapping or
thumping noise.
A Replace V-belts
If a metallic noise can be heard at rear of machine
A Tighten pulley on motor shaft
If the door is leaking
A Check door gasket. If gasket is in good condition, check the tension,
between door gasket and door frame and adjust.
If there is leaking around the glass
A Re-cement glass in door gasket.
B Replace door gasket if worn.
If water does not enter machine.
A Check the valve coils on inlet valves.
B Check wires leading to electric coils.
C Be sure manual shut-off valves are in open position.
D Check contacts on programmer.
E Check water level switch and plastic tubing.
F Check programmer switches K, N, O and Q.
If water continues to fill without stopping and programmer DOES NOT
advance
A Check water level control.
B Check that rubber tube is not plugged and that plastic tube has no air
leaks.
If water continues to flow without stopping and programmer DOES
advance
A Check inlet valves for dirt underneath the valve diaphragm. To localize,
shut off power. If water continues to flow, inlet valves have foreign material
in them and should be thoroughly cleaned.
B Check level control.
Trouble shooting