Operating instructions

44
Maintenance
The carefully considered machine design means
that preventive maintenance to reduce faults has
been reduced to a minimum. The following
measures should however be carried out at
regular intervals and to the extent determined by
the amount of time the machine is used.
Daily
• Clean the door seal and remove detergent
residue and check that there are no leaks.
• Clean the detergent compartments and wipe
down the machine with a damp cloth.
• Check that the drain valve does not leak.
• Start the machine with the program card
inserted and check that the door remains
locked while the machine is operating. Let the
machine run for 2 minutes. Stop the machine
by turning the control on the control panel to
0. Check that the door cannot be opened until
2-3 min. after the program is completed.
Every three months
• Check that valves, hoses and connections do
not leak.
• Remove any textile lint from the drain
opening.
• Remove the cover plates of the machine and
check that the V-belt of the wash motor is
undamaged and correctly tensioned.
• Wipe and clean the inside of the machine,
making sure that the control components are
protected from moisture and dirt during the
cleaning operation.
• Check level of oil in electro-lube oil dispenser.
Troubleshooting
If the machine does not start, check that:
• the machine's circuit breaker is on,
• the 0-1 (ON/OFF) switch is pressed on,
• the door is properly closed,
• the program card is inserted and the
programmer control dial is turned to I
(START).
• both taps on the wall are turned on.
Contact your service engineer if any fault
persists.
Maintenance
71
1647
72
0240
73
1619
Fig.
73
Fig.
72
Fig.
71