Operating instructions

12
Instruction for setting timing on
electro-lube oil dispensing
Pry off the switch panel cap with a screwdriver.
• Under the cap are the switches for time
setting.
• Set the "Light" and "12M" dip switches to the
"On" position. Make certain all other switches
are in "Off" position.
• The light will start flashing after a few minutes
and will continue to flash every 15th to 20th
seconds as long as the dispencer is in
operation.
• The decal shown below should be affixed at
the front of the machine and updated as
required.
2733
Electro-Lube Dispenser
1M
2M
3M
6M
12M
B
ON
LIGHT
O
F
F
2208
2207
24
IMPORTANT
NOTICE
This machine is equipped with an automatic oiler,
located at the right rear of the machine, which keeps
it lubricated for long bearing and seal life.
The amount of oil in the container is sufficient for
approximately one year's lubrication. It is of utmost
importance that the oiler does not become empty.
Therefore we recommend that the rear panel to be
removed and a visual inspection to be made on a
bimonthly basis. When the oil reaches a low level,
the cannister must be replaced with a new one
available from Wascomat as Part No. 827601.
Date Last Replaced Date Last Replaced
21
22
23
Fig.
21
Fig.
22
Fig.
23
Fig.
24