Operating instructions

10
1. Drop the knob into the larger opening in the
supply injector lid.
2. Tighten securely. Do not overtighten! Do not
use pliers or other tools to tighten the knobs!
1. Stretch the multi-rubber ring B and select the
correct size ring which will fit snuggly on the
chemical tube you are using. Ring A is used
for tubes with Ø 1/3" (8 mm).
2. Use scissors or a razor to carefully cut out the
proper size rubber ring. Wrap the rubber ring
around each tube after threading each tube
trough the plastic nipple. Run the tube trough
the compression nut to the bottom of the
compartment. Cut the end of the tube at an
angle. Hand tighten the plastic nipple on to the
compression nut.
17
Fig.
17
Fig.
18
1332
18
1331
1331
18
Installation