Operating instructions

6
Installation
5
6
7
1250
0620
0621
Mechanical installation
• Mark and drill two holes 3/8'' in (8 mm) in
diameter and approximately 3 1/2'' in. (90 mm)
deep according to the dimensions in figure 5.
• Place the machine in position. Never lift the
machine by the door or handle.
• Check that the machine is level and steady.
Use stainless or galvanized washers between
the machine and the floor.
• Insert into the holes the expansion bolts
supplied with the machine. Fit the washers
and nuts.
It is of utmost importance that the machine
is level, from side-to-side as well as front-
to-rear. If the machine is not properly
levelled, it may result in out-of-balance
cutout without a real out-of-balance in the
drum.
EX12
782 mm
30 25/32 in.
866 mm
34 3/32 in.
EX22
780 mm
30 23/32 in.
33 mm
1 5/16 in.
43 mm
1 11/16 in.
996 mm
39 7/32 in.
830 mm
32 11/16 in.
33 mm
1 5/16 in.
43 mm
1 11/16 in.
910 mm
35 13/16 in.
896 mm
35 9/32 in.
716 mm
28 3/16 in.
Fig.
5
Fig.
7
Fig.
6