Operating instructions

74
Error codes
Given below is a brief summary of all the error codes and their causes. Starting on page 5 of
this section there are fault-finding charts for all error codes.
At the end of the chapter there are also charts for faults which do not generate error codes.
Error code Cause
01E Water level not reached within set time. Take necessary action. Press START again.
02E Door status switch open during program operation. Take necessary action. Press
START again.
03E The lock has not locked the door within the set time. Take necessary action. Press
START again.
04E The temperature sensor indicates temperature below -5°C (open circuit).
05E The temperature sensor indicates temperature above 98°C (short-circuit).
06E The water level is above the safety level set for starting.
07E The water level is above the safety level set for program operation.
08E Temperature increase in water less than 5°C/10 min. (Heated machines).
10E The water level is above the safety level set for after drain.
12E The program control unit cannot read the program EPROM.
13E Program control unit receiving no response from the motor control unit.
14E Level system not temperature-calibrated. Press START to run the wash program.
Program will run, but the water level will not be optimally adjusted.
17E Door status switch open, even though the door lock is locked.
43E Unbalance switch on when motor not rotating.
45E Tacho error
Trouble shooting