Operating instructions

69
Altering text
The text that is displayed when a program is
selected and PROG.INFO is pressed can be
altered.
Go to the position between two sub-programs (see
the section ’’Looking through the program’’). Press
TEXT and ENTER. Any text that might have been
programmed in the old program is displayed.
The old text can be deleted with ERASE. Ifs the
old text is to be partially altered, the text is deleted
up to where the change is to be made and then
rewritten.
Refer to heading ’’TEXT’’ earlier in the manual
when entering text.
Completing the programming
Come out of the program you are in at the moment
(see ’’Looking through the program’’). Answer YES
to the question ’’END PROGRAM. SESSION
Y/N?’’
The questions displayed now apply to the entire
program. Check and answer the questions in the
same way as before. Press ENTER when ’’TO
END, PRESS ENTER’’ is displayed in the display
window. The last stages in the programming are
identical to those under the headings ’’Entering the
program number’’, ’’Program names’’ and ’’Saving
programs’’ earlier in the manual.
TEXT
Press:
RA-
DERA
Press:
0233
0234
Press:
Press:
0235
0236
Programming
PROGR.MODE SELECT SEQUENCE
-ABCDEFGHIJKLMNOPQRSTUVWXYZ !&/()=?;:,.*
PROGRAM 10 HEAVY SOIL 50 G
MAINWASH 10 MIN. 3 RINSES
EXTRACTION 5 MIN
PROGR.MODE SELECT SEQUENCE
END PROG. SESSION Y/N N
PROGR.MODE MAINDATA
NORMAL ACTION OFF TIME 000 SEC.
TO END. PRESS *ENTER*
Fig.
147
Fig.
148
Fig.
149
Fig.
150
ENTER
YES
ENTER
ENTER
ERASE
TEXT
147
148
149
150