Operating instructions

47
Procedure
The machine has two thumb wheel
switches for determining the speed
for low and high extraction.
The value on these switches can be
changed while the machine is in
operation.
The time for low extraction (Switch 1)
shall be programmed under question
''Low extraction XX min XX sec'' and
high extraction (switch 2) under
question ''High extraction XX mini
XX sec''.
EX12
Switch 1 is used for low extraction
and can be set on the following
values:
Position 1 340 rpm (40G)
2 420 rpm (60G)
3 510 rpm (90G)
Position 4-9 and 0 can not be used.
Switch 2:
Position 4 590 rpm (120G)
5 680 rpm (160G)
6 760 rpm (200G)
7 850 rpm (250G)
8 950 rpm (310G)
Position 0-3 and 9 can not be used.
EX22
Switch 1:
Position 1 300 rpm (40G)
2 380 rpm (60G)
3 460 rpm (90G)
Position 4-9 and 0 can not be used.
Switch 2:
Position 4 540 rpm (120G)
5 620 rpm (160G)
6 700 rpm (200G)
7 780 rpm (250G)
8 850 rpm (300G)
Position 0-3 and 9 can not be used.
Fig.
78
78
2409
1 2