Operating instructions
45
0158
0159
0160
0161
Procedure
PROG.
INFO.
MOTOR
DOOR
LOCK
PROG.
INFO.
FLUSH
HEAT
LOW
EXTR.
COLD
WATER
HOT
WATER
DRAIN
CLOSED
73
FLUSH
MOTOR
COLD
WATER
HOT
WATER
DRAIN
CLOSED
Fig.
73
Fig.
69
Fig.
70
Fig.
71
Fig.
72
Manual washing
• The indiciator lamps above the control buttons
indicate that the function is active. COLD
WATER, HOT WATER and FLUSH must be kept
pressed to remain active. Other control buttons
change function (ON-OFF) each time they are
pressed.
• Lock the door by pressing DOOR LOCK (the
lamp above the shall light up). Note that the door
must be locked for other manual operations to be
possible.
• The wash motor is started and operates with a
reversing action when the MOTOR button is
pressed.
• Water is filled with COLD WATER and HOT
WATER. FLUSH is used to wash down detergent
from compartment 1 (pre-wash) or detergent
valve 1.
• The wash water is heated by pressing HEAT.
When HEAT is pushed in, the character display
shoows:
**MANUAL HEATING OFF**
TEMP 25°C FINAL TEMP°C
SELECT TEMPERATURE. PUSH START
Indicate desiried temperature by using the key board.
Push START to begin the heating. The display will
now show:
**MANUAL HEAING ON**
TEMP 25°C FINAL TEMP 60°C
HEAT SHUT-OFF: PUSH HEAT
If a new heating temperature is desired, push HEAT to
shut off heat. A new cycle can now be selected. The
first line in the display will show whether the heat is
turned on or off.
When the programmed temperature is reached, the
heat turns off automatically.
Note that there is no temperature limit or indication of
the temperature during manual washing. Heating is
discontinued however at 208°F (98°C).
• The drain valve is operated with DRAIN. The valve
is closed when the light is on.
70
°C/°F
DOOR
LOCK
PROG.
INFO.
FLUSH
MOTOR
HOT
WATER
FLUSH
71
COLD
WATER
HOT
WATER
DRAIN
CLOSED
MOTOR
72
START
HOLD/RAPID ADV.
69