Operating instructions

43
0156
0155
Procedure
Fig.
65
Fig.
65
Fig.
65
Fig.
66
COLD
WATER
LOW
EXTR.
HEAT
START
HOLD/RAPID ADV.
PROGRAM 01 HOT
MAIN WASH 01 FILLING CV TIME 360 SEK
TEMP: 68 °F SET TEMP: 104 °F
TIME LEFT APPROX. 45 MIN
Program number
Program
section in
progress
Program name
Program time left
Programmed temperature
Water's actual temperature
Activity in progress
Program section time left
(not filling or heating)
Fig.
65
66
65
Starting the program
Press START/HOLD/RAPID ADV. button. The
wash cycle will commence and the display
window will display wash information as shown in
the figure below.
Temporary stop
• Press START/HOLD/RAPID ADV.. All active
functions (motor, filling with water and heating)
are switched off. The drain will remain closed
and the door locked.
• The program is restarted by pressing START/
HOLD/RAPID ADV. again. It starts from the
position where it had stopped unless the
pause was made during a spin cycle. The
program will then continue with the program
section after the spin cycle.
Fast forward
• Press START/HOLD/RAPID ADV. and keep
the button pressed. After 1.5 seconds, the
different program sections will be fast
forwarded at a rate of one section per
second.
• Program sections which are longer that 300
seconds (5 minutes) are however divided into
several steps for fast forwarding. At each step
the time is reduced by 300 seconds.