Operating instructions

33
Loosen the screws holding the motor mounting plate on the motor side.
Lower the motor mounting plate until the correct belt tension is obtained, as
shown in Fig. 45. Secure the motor mounting plate in place.
Motor control
On the motor control circuit board there is a yellow LED which indicates
various types of fault:
Mechanical and electrical design
Fig.
47
Fig.
48
Indication Cause
The LED flickers. Motor current is at its limit.
The LED comes on and stays on. Undervoltage in feed to motor control.
The LED flashes for 15 sec and Motor control has halted because
then the machine tries to start of wrong signals in control circuit.
again.
The LED shows double flashes. The machine has been stopped on
account of a fresh fault directly after the
last sequence described.
2433
LED for error
indication
Fuse
1
XM4
2
(XM3)
8
XM2
1
(XM5)
(XM6)
4
XM1
6
1
3
48