Operating instructions

Program start

The following conditions must be fullfilled before

the motor can start:

• Motor not overloaded.

• Door shut.

• Go-ahead signal from programmer.

When the door is locked relay K71 is activated

feeding power to the electronic control unit and the

motor is allowed to start.

Extraction

For extraction the programmer sends signals for

either low or high extraction. The operator selects

the extraction speed required by means of the

speed selector thumb wheel, on the machine front.

The speeds are selected as follows:

EX12

Low extraction High extraction

speed G-factor speed G-factor

1 340 40 4 590 120

2 420 60 5 680 160

3 510 90 6 760 200

7 850 250

8 950 310

EX22

Low extraction High extraction

speed G-factor speed G-factor

1 300 40 4 540 120

2 380 60 5 620 160

3 460 90 6 700 200

7 780 250

8 850 300

Fig.

2409

Low extraction

High extraction

Mechanical and electrical design