Operating instructions

18
Function checks
After installation the machine should be cleaned
and an empty-machine test program with
detergent carried out. Close the door.
Open the manual water and steam valves.
Add detergent and conditioner.
Choose program 6 by entering
two numbers 06.
Press START to begin test cycle The machine will
start up and the display window will show cycle
information.
Check that:
• the drum is rotating normally at all program
steps and that there are no unusual noises.
• there are no leaks from the water/steam
connections and the drain valve.
• the detergent/conditioner compartments are
flushed down.
• the door cannot be opened during the program
and not until thirty seconds after the program
has finished. No time delay on EX22 machine.
Fit the panels and covers removed during
installation. Wipe the machine clean with a damp
cloth.
If no problems were encountered, the machine is
ready for use.
0256
34
0155
36
1260
35
START
HOLD/RAPID ADV
HEAT
LOW
EXTR
COLD
WATER
Function check
Fig.
34
Fig.
35
Fig.
36