OFFICIAL WARWICK AMP OWNER MANUAL
ENGLISH 5
SAFETY HINTS - Read these instructions - Keep these instructions - Heed all warnings - Follow these instructions Caution: To reduce the risk of electric shock, do not open the amplifier’s case. Avoid exposure to rain or moisture. No user serviceable parts inside, refer all service to a qualified technician. No vessel filled with liquids, such as vases shall be placed on top of the unit. ENGLISH This symbol, wherever it appears, alerts you to the presence of dangerous non-insulated voltage inside the case.
Congratulations on the purchase of the new Warwick amplifier head/combo. Please read through these instructions before connecting and operating the device. If you keep to the guidelines set out in this manual, you will soon be able to appreciate the quality of this new Warwick amplifier. Please keep this instruction booklet handy in case you need to consult it again. Please send the PASSPORT to the address indicated therein.
PROTECTIVE CIRCUITS Your new Warwick amplifier is equipped with a series of circuits to prevent it from destruction in case of inadequate operating conditions: Power-up delay: When the unit is switched on, the SPEAKER OUT sockets are activated with a slight delay to protect the loudspeakers. Short-circuit: In the event of a short-circuit at the power amp outputs, this feature prevents the output stage transistors from destruction by quickly reducing current.
FRONT PANEL CONTROLS BASS LOW MID HIGH MID TREBLE DEEP BRIGHT MASTER MUTE PHONES Socket to plug in a bass guitar. Control + CLIP LED to adjust the input level. Switch to activate the compressor control to adjust the level of compression. Switch to activate the contour control to adjust the level of the contour (bass- and treble boost and mid cut) Control to boost/cut deep frequencies. Control to boost/cut low mids. Control to boost/cut high mids. Control to boost/cut high frequencies.
FRONT PANEL CONTROLS INPUT GAIN COMPRESSOR CONTOUR PROFET 3.2 BASS LOW MID HIGH MID TREBLE DEEP BRIGHT MASTER MUTE PHONES Socket to plug in a bass guitar. Control + CLIP LED to adjust the input level. Switch to activate the compressor control to adjust the level of compression. Switch to activate the contour control to adjust the level of the contour (bass- and treble boost and mid cut) Control to boost/cut deep frequencies. Control to boost/cut low mids. Control to boost/cut high mids.
TECHNICAL DATA - PROFET 3.2 / 5.1 Input 25 mV Preamp transistor, active controlled Poweramp fan cooled (non permanent) Equalizer Bass Low Mid Hi Mid Treble ±12dB @ 80Hz ±12dB @ 200Hz ±12dB @ 600Hz ±14dB @ 5kHz Deep Bright +12dB @ 30Hz +8dB @ 3kHz +14dB@ 16kHz Contour +20dB @ 20Hz -10dB @ 300Hz +12dB @ 10kHz Compressor adjustable Headphone 200 ohms min.
DIAGRAM - PROFET 3.2 / 5.1 CONNECT SPEAKERS - PROFET 3.2 / 5.1 Note: The minimum load of the power amplifier is 4 ohms.
67
Please see the new Warwick Bass Forum on www.warwick.de For support information please refer to support@warwick.de Visite por favor el nuevo forum Warwick de bajo en www.warwick.de Para soporte técnico e información, dirigirse por favor a support@warwick.de Por favor veja o novo Fórum de Baixos da Warwick em HYPERLINK www.warwick.de Para mais informações escreva para HYPERLINK support@warwick.de Visitare il nuovo Forum Warwick Bass: www.warwick.de Per supporto tecnico: support@warwick.
