User manual

WARSANIS 1401FM USER MANUAL

INSTALLATION GENERAL

We suggest leaving one rack space vacant between the units. When several units

are in a common rack, we recommend using one common power supply-strip to

minimize hum and ground loop problems.

INSTALLATION IN THE STUDIO

The Warsanis 1401FM should always be the last device in the audio processing

chain!

* Disable all low pass and high pass filters, input transformers and limiters/clippers

placed after the Warsanis 1401FM.

* The system group delay of the land lines, STL or satellite links must be constant

between a frequency range of 30Hz to 15.000Hz.

* The frequency response must be as flat as possible (<0,5dB recommended).

The Warsanis is shipped with a flat frequency response on the analog outputs. This

means that the de-emphases are enabled. Defeating the de-emphasis is only neces-

sary if you install the Warsanis 1401FM at the transmitter site without using the

intergraded stereo generator (pre-emphasis at the transmitter/stereo generator must

be disabled!!).

INSTALLATION AT THE TRANSMITTER SITE

* Disable all low and high pass filters, input transformers, the stereo generator, pre-

emphasis and limiters/clippers placed after the Warsanis 1401FM.

SEPARATE

PREPROCESSOR