7 in 1 Card Reader User Guide *Product Overview
- Insert Cards Correctly 1. To ensure compactness, the card reader is designed with the SD and MS card slots upside down, which better makes use of the room of the Printed Circuit Board.
MS & CF 2. Insert cards to the end gently and correctly to avoid damage to the pin. 3.
. Indications of the mini light: a) Red: power is going through. b) Blue: every time a memory card is just connected, you would see a blue glitter, meaning the recognition process is happening. c) Red + Blue: when a memory card is connected successfully and constantly, the blue light will stay with the red light, no flickering. When files are being transferred, the blue light flickers. - Troubleshooting 1. The computer does not recognize the card reader a) Unplug and plug the card again.
3. Low transfer speed a) Please note that CF and MS cards are quite outdated and do not support the speed of USB 3.0. All card readers available on the market can only get to the speed of USB 2.0, which is not the fault of card readers. b) Transfer speed is also dependent on the cards. Some cards are not of high- speed feature. Please check with card specs.
- Detailed Chip Specs & Compatibility A crystal-less USB 3.
- Warranty Activate your life-time warranty now via WARRKY.COM WARRKY promises that upon shipping out of the factory, every card reader has been tested with 4 card slots, 2 flash drives, and 1 hard disk functioning simultaneously to ensure you don't receive a deficient product. If there is any problem with the product, please contact for a free replacement. Can’t find Your question? We are always here to help: support@warrky.
