Instruction Manual
10
2600 Emrick Blvd • Bethlehem, PA 18020 • USA • 800-922-0085 • www.warrencontrols.com
5800_IOM_RevB_0413
The actuator nameplate specifies set-up parameters used (See Information Present on Control Valves sec-
tion for location of important information on valve). Do not exceed the supply pressure listed on the actua-
tor nameplate or you will damage the valve and void the warranty.
-
cated on the control valve.
and property from injury due to a valve malfunction. If the valve handles flammable, toxic, corrosive or
explosive fluids, provide for safety in the event of valve leakage or malfunction.
-
ered with insulation, it is recommended the information on the plates be transcribed on the outside of the
insulation in the same location as the plate.
INSTALLATION (CONT.)
• Close inlet and outlet stop
valves.
• Check that valve responds
through rated travel in
relation to changes in input
signal. Rated travel is
shown by position of travel
indicator on valve stem
relative to travel indicator
on yoke.
• For valves fitted with
a handwheel, manually
operate valve with no air
applied, using handwheel
through rated travel to
check freedom of movement.
Return handwheeel to its
standby position.
• Place valve in operation.
OPERATION