Specifications

8
Multipoint measurement of VTR chassis
Gage heads (LGF with EV counter) can be used to measure VTR components
at several points.
Measurement of hub runout for floppy disks
The gage head (LGB with EH counter) can be used to measure the runout of
the disk's hub.
Measuring
the run-out
When strong sideways force would
otherwise be exerted on the gage, as in this
application, take measurements indirectly
using a fixture in order to avoid subjecting
the gage to excessive loads or wear.
Parallelism measurement of copying machine
parts
Gage heads (LGD with EV counter) can be used to measure the parallelism
of copying machine parts.
Run-out measurement of motor shaft
Gage heads (LGF with EH counter) can be used to measure the radial
and axial run-out of motor shafts. The EH counter can display both
measurements simultaneously.
When strong sideways force
would otherwise be exerted on
the gage, as in this application,
take measurements indirectly
using a fixture in order to avoid
subjecting the gage to excessive
loads or wear.
Flatness measurement of tape cassette
Gage heads (LGK with EV counter) can be used to perform flatness
measurement on a tape cassette surface.
Contour measurement of CRT panel
Gage heads (LGS with EV counter) can be used to measure the surface
contour of CRT panels.
Multipoint measurement on copying machine
chassis
Gage heads (LGS with EV counter) can be used to perform multi-point
measurement on a copying machine chassis. In the case of large workpieces
an absolute type that eliminates the necessity of setting a master workpiece
will be useful.
Sorting of parts
A gage head (LGF with EB counter) can be used to sort parts by size. The
EB counter can divide the dimension into seven steps and output the signal
for sorting.
Applications