Specifications

7
Built-in sensor for machine tools
A gage head (LGM with EH counter) can be used to measure a workpiece
which has been machined on a surface grinder.
Roller to hold workpiece
Roller to support workpiece
Measurement of pipe wall thickness/outside
diameter
A gage head (LGF with EH counter) can be used to measure the wall
thickness or outside diameter of a pipe.
Pipe wall thickness
measurement
Outside diameter
measurement
Measurement of caulking height
A gage head (LGF with EB counter) can be used to measure the caulking
height of a crimp contact, etc.
Measurement of bridge-support joint
Gage heads (LGD with EG counter) can be used to measure the
displacement of a bridge-support joint. Since this measurement is performed
intermittently over a long period of time, use an absolute-type gage head
that requires power only during measurement.
Measurement of sash rail warp
Gage heads (LGF with EV counter) can be used to measurethe warp of sash
rails.
Measurement of elevator drive-rail deflection
A gage head (LGF with EB counter) can be used to measure deflection in the
drive rail of an elevator. Measured data can be output from the EB counter
to a personal computer in order to plot the displacement.
When strong sideways force would
otherwise be exerted on the gage, as in this
application, take measurements indirectly
using a fixture in order to avoid subjecting
the gage to excessive loads or wear.
Deflection data
tolerance judgement
Plotted deflection
data
Measurement of cylindrical pin displacement
Gage heads (LGB with EH counter) can be used to measure the
displacement of tape-winding capstan pins in cassette recorders. The EH
counter is capable of calculating sums and differences between two gages.
X-direction :
Measuring pin
displacement
Y-direction :
Measuring pin
displacement
Multipoint measurement on parabolic antenna
Gage heads (LGB with EV counter) can be used to perform multi-point
measurements on a parabolic antenna surface.
Measuring
displacement