Specifications

6
Applications
Multipoint measurement of automobile doors
Gage heads (LGS with EV counter) can be used to perform multi-point
measurements for automobile doors and evaluate errors against the
specified tolerances. When there are many points to measure, the use of
the LGS gage provides higher cost-effectiveness.
Measurement of hydraulic coupling dimensions
Gage heads (LGF with EH counter) can be used to measure the outside
diameters and thicknesses of hydraulic couplings used in mechanical
diggers. The EH counter allows for the calculation of sums and differences
between two gages.
Measuring outside
diameter and thickness
Measurement of camshaft displacement
Gage heads (LGF with EH counter) can be used to measure camshaft lift.
The EH counter is easily installed in the equipment panel.
Measuring
displacement
When strong sideways force
would otherwise be exerted on
the gage, as in this application,
take measurements indirectly
using a fixture in order to avoid
subjecting the gage to excessive
loads or wear.
Multipoint measurement of wheel hubs
Gage heads (LGF with EH counter) can be used to inspect a wheel hub for
compliance with runout limits.
Measurement of aircraft fuselage distortion
Gage heads (LGD with EV counter) can be used to help measure changes
in stress generated in an aircraft fuselage. For the very large workpiece,
the use of an absolute type gage head is recommended, since the master
settings then need to be done just once.
Multipoint measurement of turbine blades
Gage heads (LGB with EV counter) can be used to perform multi-point
measurements of gas turbine blades.
Built-in sensor for inside diameter measurement
tools
A gage head (LGF with EH counter) can be used to measure inside
diameters.
Inspecting rivets
A gage head (LGD with EG counter) can be used to inspect the condition of
fixing of a rivet or bolt. Inspection of parts press-fitted is also done in the
same way.