Electro-Magnetic Single Disc Clutch and Brake Combination EM and EMER Service Manual P-2055-WE SM305gb - rev 11/04
We, WARNER ELECTRIC EUROPE, 7, rue Champfleur, B.P. 20095, F-49182 St Barthélemy d’Anjou Cedex declare that the combined clutches and brakes are made in our factory from St Barthélemy d’Anjou, and hereafter designated : EM and EMER are exclusively designed for incorporation into a machine and to be assembled with other equipments to create a machine.
Symbol designating an action that might damage the brake Symbol designating an action that might be dangerous to human safety 2 Precautions and restrictions on use 3 Installation 2.1 Restrictions on use 3.1 Transport / storage This equipment is designed for dry running in an IP 64 envelope. Any link to a casing with oil bath must have non standard, reinforced strength seals. Our pre-assembled equipment is supplied in individual packaging with a label stating the order configuration.
3.3.2 Examples of typical assemblies SHAFT - INPUT 4.1 All works on the electrical connections have to be made with power off. FLANGE - SHAFT - OUTPUT Be sure to comply with the nominal supply voltage. Low supply level results in a reduction of start distance and transmissible torque. Gear Sprocket Important recommendations FOOT The connecting wires should be of sufficient cross section to avoid drops in the voltage between the supply and the equipment being supplied.
Appendixes 5.
Warranty Warner Electric LLC warrants that it will repair or replace (whichever it deems advisable) any product manufactured and sold by it which proves to be defective in material or workmanship within a period of one (1) year from the date of original purchase for consumer, commercial or industrial use. This warranty extends only to the original purchaser and is not transferable or assignable without Warner Electric LLC’s prior consent. Warranty service can be obtained in the U.S.A.
