Owners manual

WARN® INDUSTRIES PAGE 8 83138A1
Installation continued
5. Install the main section of the bucket (Figure 6).
The edge with larger bend will be secured to the
blade in the area the wear bar was removed from.
Install M10x25mm carriage bolts (previously re-
moved) loosely until all parts of the bucket have
been attached to the plow.
6. Install both right and left sections of bucket (Figure
7). Secure the side sections of the bucket to the
main section with 3/8” button head bolts.
Secure the side sections of the bucket to the plow
with 3/8” carriage bolts. A 1/2” shim washer must
be installed between both side sections and the
plow See Figure 1.
Blades may have either a round or square hole
on top surface of outside blade rib. See below for
proper hardware use.
Torque all fasteners at this time.
7. Install the wear bar on the bottom of the bucket
main section (Figure 8). Use 3/8” carriage bolts
to secure the wear bar. The heads of the bolts
should be inside the bucket and the 3/8” nuts will
be under the bucket.
Torque all fasteners at this time.
Figure 6
Figure 7
Figure 8
Carriage Bolts
Button Head Bolts